KDC User Manual MULTIPLE SPECIAL BARCODES
373
17. Appendix G – Multiple Special Barcodes
This chapter explains how to make a multiple configuration barcode for the KDC to configure
multiple KDC settings by scanning one barcode. The KDC provides special barcodes that enable
changes to the KDC configuration; but, this current barcode changes only one configuration.
New
KDC firmware VersionR_305 introduces a feature to enable the user to make one special barcode
to change multiple KDC configurations.
17.1 KDC20/100/250/270L/270D/350L/410/411/415/470L/
470D/500L
⚫ Barcode type Code128 is used to make a single special barcode and its format is as follows:
<FNC3><Barcode String>
Here, the <FNC3> is a Code 128 control character and the <Barcode String> is an ASCII string for each KDC
configuration.
⚫ The multiple configuration Code128 barcode format is as follows and has a control
character and series of barcode strings.
<FNC3><Barcode String 1>;;;;; <Barcode String N>
Here, the <FNC3> is a Code 128 control character and the <Barcode String 1> and <Barcode String N> are an
ASCII string for each KDC configuration. The ‘;’ is a separator for each configuration’s barcode string. Please
see user manual for the <Barcode String> for KDC configuration.
⚫ Example: Assume the user is changing the following configurations with one barcode.
➢ Change Wedge/Store to “Wedge Only” ➔ <FNC3>82000
➢ Change Termination Character to “None” ➔ <FNC3>88000
➢ Change Bluetooth “Auto PowerOff” to “Disabled” ➔ <FNC3>64010
<FNC3>82000;88000;64010
To Next Page
