KDC User Manual BLUETOOTH
113
The UP button shows the Bluetooth connection status and the DOWN button shows the time
when this option is disabled.
The user should first un-pair the KDC from the Bluetooth host to change the Connect
Device setting on the scanner to a different Bluetooth profile.
Auto Connect
This feature enables the KDC to automatically connect to the host device when the KDC is
powered on. KDC500 doesn’t support Auto Connect.
IMPORTANT: Until the host device and the KDC have been fully tested, it is strongly
recommended that this feature be set to ‘Disabled’, because a host device that does not
support this feature could cause problems, such as power loss or upload delays.
The KDC automatically tries to connect to the host 10 times within the duration of
two minutes when
Bluetooth
power is ON,
Bluetooth
is disconnected, Auto
Connect is enabled, and system Sleep Timeout is set to 5 seconds.
Auto Reconnect
This feature enables the KDC to automatically connect to the host device when the KDC is
disconnected from a host.
The KDC tries to connect automatically to the host 10 times within the duration of
two minutes if Bluetooth is disconnected.
Auto Power On
The Auto Power On option Enables the KDC to automatically power on Bluetooth when the
SCAN button is pressed. The default setting is Disabled. KDC500 doesn’t support this option.
Users should press the scan button for the duration defined in the BT Config Power-
on time option. The host program may have to open the COM port again in order to
be reconnected with the KDC.
PWR ON Time
The PWR On Time option works in conjunction with the Auto Power On option. The default
value is Disabled. If the KDC Bluetooth power is off, you may turn on the Bluetooth power by
pressing the SCAN button for the PWR On Time option value. KDC500 doesn’t support this
option.
To Next Page
Loading...
