KoamTac KDC20 - Page 99

KDC User Manual BLUETOOTH
99
Button Lock
This option enables the user to lock or unlock the KDC scan and scroll buttons.(KDC500 doesn’t
support)
Beep Alert
⚫ Beep Sound: Enables or disables KDC beep sound.
⚫ Power On Beep: Enables or disables beep sound when KDC power is on.
⚫ Beep On Connect: Enables or disables beep sound when KDC is connected to the host.
⚫ Beep On Scan: Enables or disables beep sound when KDC is scanning.
⚫ Beep On MS Card (KDC500 only) : Enables or disables beep sound when KDC reads a
MS Card.
⚫ Beep On IC Card (KDC500 only) : Enables or disables beep sound when KDC reads an
EMV Contact Card.
⚫ Beep On NFC Card (KDC500 only) : Enables or disables beep sound when KDC reads
an NFC Tag or EMV Contactless Card.
Beep Volume
This option enables the user to adjust the beep volume from High to Low.
MFi Mode (KDC20i/30i/200i/250i/270i/300i/350i/400i/470i)
This option Enables user to enable or disable MFi mode. MFi mode supports SPP and MFi
Bluetooth profiles. Non-MFi mode supports SPP, SPP2.0, HID iOS and HID normal.
Vibrator(KDC20/30/270/280/350)
Enables, disables and configure KDC vibrator.
• There are two additional options for KDC vibrator configuration.
o Scan Success ➔ Specify the number of vibration when scan successfully.
o Scan Failure ➔ Specify the number of vibration when scan failed.
Auto Exit
This option enables KDC to automatically exit KDC Menus.
Port Status
This option enables users to enable or disable KDC port messages.
Display Format
There are various selections of display format; Time & Battery, Type & Time, Type & Battery,
Memory Status, Barcode only and Graphics.
The Graphics option enables to display ‘O’ for scan success and ‘X’ for scan failure.