36
3–2: MIDI 2 (MIDI Filter –2)
3–2a: Enable JS X as AMS, Enable JS+Y, Enable JS–
Y, Enable Ribbon
Enable JS X as AMS
Specify whether or not MIDI pitch bend messages (the X
axis of the TRITON’s joystick) will be received to control the
AMS (
☞p.209 “Alternate Modulation Source (AMS)”) effect
assigned to JS X. (This is not a filter for MIDI pitch bend
message reception.)
Enable JS+Y
Specify whether or not MIDI control change #1 (the +Y axis
of the TRITON’s joystick, or specified as the “B” assignment
of a realtime control knob) will be transmitted or received.
Enable JS–Y
Specify whether or not MIDI control change #2 (the –Y axis
of the TRITON’s joystick, or specified as the “B” assignment
of a realtime control knob) will be transmitted or received.
Enable Ribbon
Specify whether or not MIDI control change #16 (the TRI-
TON’s ribbon controller, or specified as the “B” assignment
of a realtime control knob) will be transmitted or received.
3–3: MIDI 3 (MIDI Filter –3)
Specify whether or not the effects of A and B modes for the
REALTIME CONTROL knobs [1], [2], [3] and [4] will be
transmitted and received. In “A” mode, the MIDI control
message for each knob is fixed. In “B” mode, the message for
each knob can be assigned in Controller tab (4–5).
3–3a: Enable Realtime Control Knob –1...4
Enable Realtime Control Knob –1
Specify whether or not the “A” mode MIDI control message
#74 (the TRITON’s low pass filter cutoff frequency) and the
“B” mode MIDI control message assigned to knob [1] will be
transmitted and received.
Enable Realtime Control Knob –2
Specify whether or not the “A” mode MIDI control message
#71 (the TRITON’s low pass filter resonance or high pass fil-
ter cutoff frequency) and the “B” mode MIDI control mes-
sage assigned to knob [2] will be transmitted and received.
Enable Realtime Control Knob –3
Specify whether or not the “A” mode MIDI control message
#79 (the TRITON’s filter EG intensity) and the “B” mode
MIDI control message assigned to knob [3] will be transmit-
ted and received.
Enable Realtime Control Knob –4
Specify whether or not the “A” mode MIDI control message
#72 (the EG release time for the TRITON’s filter and ampli-
fier) and the “B” mode MIDI control message assigned to
knob [4] will be transmitted and received.
3–4: MIDI 4 (MIDI Filter –4)
3–4a: Enable SW1, Enable SW2, Enable Other Con-
trol Change
Enable SW1, Enable SW2
Specify whether or not the effect of the [SW1] and [SW2]
keys will be transmitted and received. The function of these
keys is specified in Controller tab (4–4).
This filter setting is valid for settings of SW1 Mod.:CC#80,
SW2 Mod.:CC#81, or Porta.SW:CC#65.
Enable Foot Pedal/Switch
Specify whether or not the effect of the ASSIGNABLE
PEDAL/SWITCH will be transmitted and received. The
function is assigned in Global P2.
This filter setting is valid when a MIDI control change is
assigned.
Enable Other Control Change
Specify whether or not MIDI control messages not covered
in the preceding items MIDI Filter 1–4 will be transmitted
and received.
0–1
3–2a
0–1
3–3a
0–1
3–4a
To Next Page
Loading...
Need help?
General
