Combination
P0
P1 P2 P3 P4 P7 P8 P9
43
8–3a: Ctrl Ch [Ch01...16, Gch, All Routed]
This parameter specifies the MIDI channel that will be
used to control effect dynamic modulation (Dmod), pan
following the insert effect (CC#8), Send 1 (CC#93), and
Send 2 (CC#91).
The channel number of the timbre routed through this IFX
will be followed by a “*” displayed at the right of Ch01–16.
If two or timbres with different MIDI channel settings are
routed through the same IFX, this parameter specifies which
of these channels will be used to control the effect.
Gch: The global MIDI channel “MIDI Channel” (Global
mode P1: 1–1a) will be used to control the effect. Normally
you will set this to Gch.
All Routed: The channel of any timbre routed through this
effect can be used to control the effect. (Channels of each
routed timbre will be indicated by “*”.)
If the “BUS Select” (8–1b) of a timbre for which a drum
program is selected is set to DKit, the MIDI channel of
that timbre will be valid if any IFX1–5 is set to All
Routed, regardless of the “BUS Select” (Global P5: 5–
2b) settings or the settings of the “DrumKit IFX Patch”
page menu command.
☞ For details on master effects, refer to p.150 “8. Effect
Guide.”
9–1: Master FX
Here you can select the type of each master effect, turn it
on/off, and make chain and master EQ settings. These set-
tings are the same as in Program mode (
☞“Program 9–1:
Master FX”).
▼ 9–1: Page Menu Command
9–1A: Copy Master Effect
☞ “Program P9: 9–1A: Copy Master Effect.”
However, the MIDI control channel that is specified by “Ctrl
Ch” of the MFX 1 and 2 tabs will not be copied.
9–1B: Swap Master Effect
☞ “Program P9: 9–1B: Swap Master Effect.”
However, the MIDI control channel that is specified by “Ctrl
Ch” of the MFX 1 and 2 tabs will not be swapped.
9–2: MFX 1 (Master Effect1)
9–3: MFX 2 (Master Effect2)
Here you can set the parameters for the MFX 1 and 2 effects
that were selected in the Master FX tab (
☞p.155).
Combination P9: Edit-Master FX
9–1
0–1A
9–1A
9–1B
0–1A
9–2a