Song Play
P0
P1 P2 P3 P7 P8 P9
103
0–3: Mixer 1–8 (Mixer T01–08)
0–4: Mixer 9–16 (Mixer T09–16)
Set the pan and volume for each track (channel).
0–3(4)a: Program Category
This area displays part of the category name for the program
used by each track.
0–3(4)b: Pan
Pan (Panpot) [RND, L001...C064...R127]
Set the panning for each track (channel) 1–16 (☞Sequencer
P0: 0–3b).
Tracks whose “Status” (1–1a, 2a) is INT or BTH can
receive MIDI control change (CC) #10 to control the
panpot. When receiving CC#10, a value of 0 or 1 will be
far left, 64 will be center, and 127 will be far right.
Tracks 1–16 will be controlled by MIDI channels 1–16
respectively.
0–3(4)c: Volume
Volume [0...127]
Set the volume of each track (channel) 1–16.
Tracks whose “Status” (1–1a, 2a) is INT or BTH can
receive MIDI control change (CC) #7 to control the vol-
ume. The actual volume of a track is determined by
multiplying the MIDI volume (CC#7) and expression
(CC#11) values. Tracks 1–16 will be controlled by MIDI
channels 1–16 respectively.
0–5: Preference
Here you can make settings for playing SMF files consecu-
tively, and make settings for the metronome.
0–5a: Next File
Specify whether or not the next file will be played back in
succession when the currently selected SMF finishes play-
ing.
Chain to next file
Checked: When the currently selected file finishes playing,
the next file will automatically be selected.
Auto Start
Checked: When the currently selected SMF finishes playing,
the next file will automatically begin playing. This is valid
when “Chain to next file” is checked.
0–5b: Metronome Setup
Make settings for the metronome.
Sound [On, Off]
On: The metronome will sound during playback. The sound
of the metronome will be output to the bus selected by “BUS
Select.”
BUS (Output) Select (BUS Select)
[L/R, L, R, 1, 2, 3, 4, 1/2, 3/4]
Specify the output destination of the metronome sound
(
☞Sequence P0: 0–7b).
Level [000...127]
Set the volume of the metronome.
▼ 0–5: Page Menu Command
☞ “▼ 0–1: Page Menu Command.”
However, “Solo Selected Track” (0–1B) can not be
selected.
0–1a
.
.
.
0–1g
0–1
0–3a
0–3b
0–3c
0–1a
.
.
.
0–1g
0–5
0–5a
0–5b
To Next Page
