Appendices
229
A
Are you sure ?
C
Can’t calibrate
Can’t copy/swap double size effect
Can’t open pattern Continue ?
Completed
D
Destination and source are identical
Destination from-measure within the limits of source
Destination is empty
Destination measure is empty
Destination multisample already exists
Destination multisample and source multisample are
identical
Destination sample already exists
Destination sample data used in source sample
Destination sample is empty
Destination song is empty
Directory is not empty
Disk not formatted
E
Error in formatting medium
Error in reading from medium
Various messages
Meaning: This message asks you to confirm execution. To
execute press the OK button. To cancel, press the
Cancel button.
Meaning: Calibration could not be performed correctly.
Action: Try again.
Meaning: When copying or swapping an insertion effect,
you attempted to place a double-size effect in
IFX1 or IFX5.
Action: Modify your settings so that a double-size effect is
not moved to IFX1 or 5, and execute again.
Meaning: When you finished recording or editing, it was
not possible to allocate enough memory to open
the pattern that was Put into the track. (When it
must be opened automatically.) If you press the
OK button, the pattern data will be deleted, and
the recorded or edited content will be saved. If
you press the Cancel button, the recorded or
edited content will be discarded.
Meaning: Execution of the command ended normally.
Meaning: When copying or bouncing, the same cue list,
song, track or pattern was selected for both the
source and destination.
Action: Select a different cue list, song, track, or pattern
for the source and destination.
Meaning: When executing the Move Measure command for
all tracks or within the same track, the specified
destination measure is within the source range.
Action: Set a destination measure that is outside of the
source range.
Meaning: When editing, the track or pattern that was speci-
fied as the destination contains no musical data.
Action: Select a track or pattern that contains musical
data.
Meaning: The measure that was specified as the destination
contains no data.
Action: Specify a destination measure that contains data.
Meaning: A multisample already exists at the destination
(save location) multisample.
Action: Either delete the multisample at the destination
(save location), or change the save destination
multisample number.
Meaning: The same multisample is selected for the source
and destination.
Action: Select different multisamples for the source and
destination.
Meaning: A sample already exists at the destination (save
location).
Action: Either delete the sample at the destination (save
location), or change the save destination sample
number.
Meaning: Since the sample data at the destination (save
location) is also used by the source sample, it can-
not be overwritten.
Action: Without using Overwrite, specify a different sam-
ple for the destination (save location).
Meaning: The sample for editing is empty.
Meaning: The song that was specified as the copy destina-
tion or bounce destination does not exist.
Action: Execute the Create New Song command in the
dialog box that appears when a new song is
selected before copying or bouncing.
Meaning: When deleting a directory, files or directories exist
within that directory.
Action: Delete all directories or files within the directory.
Meaning: When you attempted to perform a high-level for-
mat (quick format) of media, the media had not
been physically formatted yet.
Action: Execute the Disk mode Utility “Format” to physi-
cally format the media (full format).
Meaning: An error occurred while performing a physical
format (full format) or high-level format (quick
format) of the media.
Action: Use other media.
Meaning: An error occurred while reading data from a
medium.
To Next Page
Loading...
Need help?
General
