Sequencer
P0
P1 P2 P3 P4 P5 P6 P7 P8 P9
77
8–4(–8)a: Ctrl Ch [Ch01...16, All Routed]
Select the MIDI channel that will control effect dynamic
modulation (Dmod), pan following the insert effect
(CC#8), Send 1 (CC#93), and Send 2 (CC#91).
An asterisk “*” will appear at the right of the channel num-
ber Ch01–16 for tracks that are routed through these IFX. If
you have routed multiple tracks that have differing MIDI
channel settings, you can specify here which of these chan-
nels will be used to control the effect.
All Routed: Control can be performed from any of the MIDI
channels of the tracks that are routed.
If you have selected DKit as the “BUS Select” (8–1b) of
a track for which a drum program is selected, the MIDI
channel of that timbre will be valid if All Routed is
selected for any one of IFX 1–5, regardless of the “BUS
Select” (Global P5: 5–2b) setting of the drum kit, or of
the setting of the “DrumKit IFX Patch” page menu
command.
☞ For details on the master effects, refer to p.150 “8. Effect
Guide.”
9–1: Master FX
Here you can select the type of master effects, turn them on/
off, and make chain and master EQ settings. These parame-
ters are the same as in Program mode.
☞“Program 9–1: Mas-
ter FX (Master Effects)”
▼ 9–1: Page Menu Command
9–1A: Copy Master Effect
☞ “Program P9: 9–1A: Copy Master Effect.”
However, the MIDI control channel specified in “Ctrl Ch” of
the MFX 1 and 2 tabs will not be copied.
9–1B: Swap Master Effect
☞ “Program P9: 9–1B: Swap Master Effect.”
However, the MIDI control channel specified in “Ctrl Ch” of
the MFX 1 and 2 tabs will not be swapped.
9–2: MFX 1
9–3: MFX 2
Here you can set the parameters of the MFX 1 and 2 effects
that were selected in the Master FX tab (
☞p.155).
Sequencer P9: Master Effect
9–1
0–1A
9–1A
9–1B
0–1I
0–1J
0–1A
9–2a
To Next Page
Loading...
Need help?
General
