58
Enable After Touch
Specify whether or not MIDI after touch messages will be
received.
Enable Damper
Specify whether or not MIDI control message #64 Hold
(damper pedal) will be received.
Enable Portamento SW
Specify whether or not MIDI control message #65 Porta-
mento On/Off will be received.
3–3: MIDI 2 1–8 (MIDI Filter –2 T01–08)
3–4: MIDI 2 9–16 (MIDI Filter –2 T09–16)
3–3(4)a: Enable JS X as AMS, Enable JS+Y, Enable
JS–Y, Enable Ribbon
Enable JS X as AMS
Allow incoming MIDI pitch bend messages (the X-axis of
the TRITON’s joystick) to control the AMS (
☞“Alternate
Modulation Source”) that is specified for JS X. (This is not a
reception filter for MIDI pitch bend messages.)
Enable JS+Y
Specify whether or not MIDI control message #1 (the +Y
axis of the TRITON’s joystick, or assigned to B-mode of the
REALTIME CONTROL knobs [1]–[4]) will be received.
Enable JS–Y
Specify whether or not MIDI control message #2 (the –Y axis
of the TRITON’s joystick, or assigned to B-mode of the
REALTIME CONTROL knobs [1]–[4]) will be received.
Enable Ribbon
Specify whether or not MIDI control message #16 (the TRI-
TON’s ribbon controller, or assigned to B-mode of the
REALTIME CONTROL knobs [1]–[4]) will be received.
3–5: MIDI 3 1–8 (MIDI Filter –3 T01–08)
3–6: MIDI 3 9–16 (MIDI Filter –3 T09–16)
Here you can specify whether the A and B-mode effects of
the REALTIME CONTROL knobs [1]–[4] will be transmitted
and received. The A-mode MIDI controller messages for
each knob are fixed. The B-mode messages can be set in
Sequencer 4–7: Controller tab.
3–5(6)a: Enable Realtime Control Knob 1...4
Enable Realtime Control Knob 1
Specify whether or not the A-mode MIDI control message
#74 (the TRITON’s low pass filter cutoff frequency) and the
B-mode MIDI control message will be received.
Enable Realtime Control Knob 2
Specify whether or not the A-mode MIDI control message
#71 (the TRITON’s low pass filter resonance or high pass fil-
ter cutoff frequency) and the B-mode MIDI control message
will be received.
Enable Realtime Control Knob 3
Specify whether or not the A-mode MIDI control message
#79 (the TRITON’s filter EG intensity) and the B-mode MIDI
control message will be received.
Enable Realtime Control Knob 4
Specify whether or not the A-mode MIDI control message
#72 (the release time of the TRITON’s filter and amplifier
EG’s) and the B-mode MIDI control message will be
received.
3–7: MIDI 4 1–08 (MIDI Filter –4 T01–08)
3–8: MIDI 4 9–16 (MIDI Filter –4 T09–16)
0–1c
0–1e
0–1g
0–1
3–3a
0–1c
0–1e
0–1g
0–1
3–5a
0–1c
0–1e
0–1g
0–1
3–7a
To Next Page
Loading...
Need help?
General
