Lexmark C925 - Understanding the Printer Menus; Menus List

Diagnostic information 2-55
5041-030
Go Back
Previous
Next
58 Too Many Flash
Options
Too many flash options are installed. To continue:
1. Turn off and unplug the printer.
2. Remove the excess flash memory.
3. Plug in the printer, and turn it on.
If this does not fix the problem, replace the RIP board. See “RIP board removal” on
page 4-46.
58 Too Many Trays
Attached
1. Turn off and unplug the printer.
2. Remove options until the supported number of options for that model. Models C925
supports three additional trays.
3. Plug in the printer, and turn it on.
61 Defective Disk • Select Continue to clear the message and continue printing.
• Install a different hard disk before performing any operations that require a hard disk.
• If this does not fix the problem, replace the RIP board. See “RIP board removal” on
page 4-46.
62 Disk full • Select Continue to clear the message and continue processing.
• Any information not previously stored on the hard disk is deleted.
• Delete fonts, macros, and other data stored on the hard disk.
• Install a larger hard disk.
• If this does not fix the problem, replace the RIP board. See “RIP board removal” on
page 4-46.
63 Unformatted disk • Select Continue to clear the message and continue printing.
• Format the disk.
• If the error message remains, replace the hard disk.
• If this does not fix the problem, replace the RIP board. See “RIP board removal” on
page 4-46.
64 Unsupported disk
format
• Select Continue to clear the message and continue printing.
• Format the disk.
• If the error message remains, replace the hard disk.
• If this does not fix the problem, replace the RIP board. See “RIP board removal” on
page 4-46.
80 Fuser Near Life
Warning
• Select Continue to clear the message and continue printing.
• Show Me, View Supplies, and Tell Me More displays additional information.
• Order a replacement fuser. When print quality is reduced, install the new fuser using the
instruction sheet that comes with the replacement fuser.
Note: Be sure to reset the fuser count.
• If this does not fix the problem, replace the RIP board.See “RIP board removal” on
page 4-46.
80 Fuser Life Warning • Select Continue to clear the message and continue printing.
• Show Me, View Supplies, and Tell Me More displays additional information.
• Order a replacement fuser. When print quality is reduced, install the new fuser using the
instruction sheet that comes with the replacement fuser.
Note: Be sure to reset the fuser count.
• If this does not fix the problem, replace the RIP board. See “RIP board removal” on
page 4-46.
80 Replace Fuser • Show Me, View Supplies, and Tell Me More displays additional information.
• Replace the fuser. See “Fuser removal” on page 4-51.
Note: Be sure to reset the fuser count.
• If this does not fix the problem, replace the system board. See “RIP board removal” on
page 4-46.
Error code Action