Quick Reference Table
The following table contains situations frequently encountered by users while working with
inverters. Refer to the typical and practical situations in the table to quickly and easily locate
answers to your questions.
Situation Reference
I want to run a slightly higher rated motor than the inverter’s rated capacity.
p. 208
I want to configure the inverter to start operating as soon as the power source is
applied.
p. 85
I want to configure the motor’s parameters.
p.144
I want to set up sensorless vector control.
p.147
Something seems to be wrong with the inverter or the motor.
p. 226, p.339
What is auto tuning? p.144
What are the recommended wiring lengths? p. 226, p.339
The motor is too noisy. p. 176
I want to apply PID control on my system. p. 136
What are the factory default settingss for P1–P7 multi-function terminals? p. 30
I want to view all of the parameters I have modified. p. 184
I want to review recent fault trip and warning histories. p. 304
I want to change the inverter’s operation frequency using a potentiometer. p. 57
I want to install a frequency meter using an analog terminal. p. 31
I want to display the supply current to motor. p. 60
I want to operate the inverter using a multi-step speed configuration. p. 78
The motor runs too hot. p. 207
The inverter is too hot. p. 215
The cooling fan does not work. p. 345
I want to change the items that are monitored on the keypad. p. 203
To Next Page
Loading...
