LSIS sv-ip5a

viii
TECHNICAL STANDARDS APPLIED
The standards applied in order to comply with the essential requirements of the Directives 73/23/CEE
"Electrical material intended to be used with certain limits of voltage" and 89/336/CEE
"Electromagnetic Compatibility" are the following ones:
• EN 50178 (1997)
“Electronic equipment for use in power installations”.
• EN 61800-3/A11 (2000)
“Adjustable speed electrical power drive systems. Part 3: EMC product
standard including specific methods”
• EN 55011/A2 (2002)
“Industrial, scientific and medical (ISM) radio-frequency equipment.
Radio disturbances characteristics. Limits and methods of
measurement”
•EN 61000-4-2/A2 (2001)
“Electromagnetic compatibility (EMC). Part 4: Testing and
measurement techniques. Section 2: Electrostatic discharge immunity
test.
• EN 61000-4-3/A2 (2001)
“Electromagnetic compatibility (EMC). Part 4: Testing and
measurement techniques. Section 3: Radiated, radiofrequency,
electromagnetic field immunity test.
• EN 61000-4-4/A2 (2001)
“Electromagnetic compatibility (EMC). Part 4: Testing and
measurement techniques. Section 4: Electrical fast transients / burst
immunity test.
• EN 61000-4-5/A1 (2000)
“Electromagnetic compatibility (EMC). Part 4: Testing and
measurement techniques. Section 5: Surge immunity test.
• EN 61000-4-6/A1 (2001)
“Electromagnetic compatibility (EMC). Part 4: Testing and
measurement techniques. Section 6: Immunity to conducted
disturbances, induced by radio-frequency fields.
• CEI/TR 61000-2-1
(1990)
“Electromagnetic compatibility (EMC). Part 2: Environment.
Environment description for low-frequency conducted disturbances and
signalling in public low voltages supply systems”
• EN 61000-2-4 (1997)
“Electromagnetic compatibility (EMC). Part 2: Environment.
Compatibility level in industrial plants for low-frequency conducted
disturbances”
• EN 60146-1-1/A1 (1997)
“Semiconductor convertors. General requirments and line commutated
convertors. Part 1-1: Specifications of basic requirements”