EasyManuals Logo

LSIS sv-ip5a User Manual

LSIS sv-ip5a
210 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #42 background imageLoading...
Page #42 background image
Chapter 4 - Operation
4-3
DRV▶ Acc. time
01 10.0 sec
DRV▶ Acc. time
01 10.0 sec
DRV▶ Acc. time
01 10.0 sec
DRV▶ Acc. time
01 15.0 sec
DRV▶ Acc. time
01 15.0 sec
4.1.2 Parameter setting and changing
1) Press [MODE] key until the desired parameter group is displayed.
2) Press [] or [] keys to move to the desired parameter code. If you know the desired parameter code,
you can set the code number of each parameter group in “Jump code”, except DRV group.
3) Press [PROG] key to go into the programming mode, the cursor starts blinking.
4) Press [SHIFT/ESC] key to move the cursor to the desired digit.
5) Press [] or [] keys to change the data.
6) Press [ENT] key to enter the data. The cursor stops blinking.
Note: Data cannot be changed when 1) the parameter is not adjustable during the inverter is running (see the
function list), or 2) Parameter Lock function FU2-94 [Parameter Lock] is activated.
EX) Changing Accel time from 10 sec to 15 sec
1) LCD keypad
Move to the desired code to change.
Press the [PROG] key.
A Cursor () will appear.
Use the [SHIFT] key to move the cursor.
Change the data using [], [] keys.
Press the [ENT] key to save the value into memory.
The Cursor will disappear.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the LSIS sv-ip5a and is the answer not in the manual?

LSIS sv-ip5a Specifications

General IconGeneral
BrandLSIS
Modelsv-ip5a
CategoryController
LanguageEnglish

Related product manuals