ii
WARNING
Do not remove the cover while power is applied or the unit is in
operation.
Otherwise, electric shock could occur.
Do not operate the inverter with the front cover removed.
Otherwise, electric shock can occur due to the exposed terminals and bus bars.
Do not remove the cover except for periodic inspections or wiring,
even if the input power is not applied.
Otherwise, electric shock can occur due to accessing capacitor banks.
Wiring and periodic inspections should be performed at least 10
minutes after disconnecting the input power and after checking the DC
link voltage is discharged with a meter (below 30VDC).
Otherwise, electric shock could occur.
Operate the switches with dry hands.
Otherwise, electric shock could occur.
Do not use the cable when its insulating tube is damaged.
Otherwise, electric shock could occur.
Do not subject the cables to scratches, excessive stress, heavy loads
or pinching.
Otherwise, electric shock could occur.
CAUTION
Install the inverter on a non-flammable surface. Do not place flammable
materials nearby.
Otherwise, fire could occur.
Disconnect the input power if the inverter has been damaged.
Otherwise, it could result in a secondary accident and fire.
Do not touch the inverter after shutting down or disconnecting it. It will
remain hot for a couple of minutes.
Otherwise, bodily injuries such as skin-burn or damage could occur.
Do not apply power to a damaged inverter or to an inverter with parts
To Next Page
Loading...
Need help?
General
