Manitowoc Published 08-12-19, Control # 224-13_v2 4-29
MLC650 OPERATOR MANUAL SET-UP AND INSTALLATION
Deploy Rotating Bed Platforms
The rotating bed platforms are attached to the rotating bed
and must be flipped up or down to the working position. Each
platform includes hinged platform braces for quick assembly.
NOTE: Install the handrails when available, if they are not
available use the anchors (Figure 4-2
) supplied to
attach safety harnesses.
The upper rear platforms include an area which
must be flipped up when the rotating bed jacking
cylinders are to be placed into the stored position.
The upper rear platforms have two positions for
shipping. Pin position 6a is used for shipping with a
live mast and pin position 6b is used for shipping
without a live mast.
See Figure 4-24
for the following procedure:
1. Remove safety pin (1) from the storage bracket (4).
2. Swing platform up (upper rear platforms swing down).
3. Remove the safety pin (1) from the hitch pin (3) and
remove the hitch pin.
4. Swing platform brace(s) (2) out from the platform.
5. Store hitch pin (3) using safety pin (1).
6. Lower platform into position and align platform brace(s)
with rotating bed brackets.
7. Install pin and secure using safety pin (1).
8. Install handrails (9) along both sides of the rotating bed
according to labels (10) and secure the handrails with
lanyard pins (7).
9. Repeat the procedure for each platform section.
WORKING POSITION
Item Description
1 Safety Pin
2 Platform Brace
3Hitch Pin
4 Storage Bracket
5 Hinge Bracket
6 Quick Release Pin
7 Lanyard Pin
8a Working Position
8b Setup Position
9 Handrail
10 Label
FIGURE 4-24 continued
To Next Page
Loading...
