Manitowoc MLC650 User Manual

Manitowoc Published 08-12-19, Control # 224-13_v2 4-169
MLC650 OPERATOR MANUAL SET-UP AND INSTALLATION
4
Deploying Rotating Bed Jacking Cylinders
See Figure 4-130 for the following procedure:
1. Remove the safety pin and clevis pin (1) from the
outrigger strut (2) in the stored position.
2. Remove the safety pin and clevis pin (3) from the
rotating bed lug (4) in the stored position.
3. Swing the outrigger beam assembly (5) from the stored
position to the working position.
4. Attach the outrigger strut to the outrigger assembly lug
(13) using the clevis pin and safety pin removed in
step 1
. Attach the other end of the strut to the rotating
bed lug using the clevis pin and safety pin removed in
step 2
.
5. Remove the jacking cylinder pin (6) and safety pin from
the outrigger beam assembly in the stored position.
6. Remove the jacking cylinder pin (7) and safety pin from
the jacking cylinder lug that secures the rotating bed
jacking cylinders in the stored position.
7. Using the remote control, lower the rotating bed jacking
cylinder (8) to the working position.
8. Install the jacking cylinder pin and safety pin removed in
step 5
to secure the rotating bed jacking cylinder in the
working position.
9. Remove the outrigger pad locking pins (9) and the
outrigger pad (11) from the stored position.
10. Install the outrigger pad locking pin back into the lug on
the rotating bed (stored position).
11. Place the outrigger pad on the ground below the jacking
cylinders and remove the U-shaped locking pin (10)
from the outrigger pad.
12. Using the remote control, extend the rotating bed jacking
cylinders until the rod end (12) of the cylinder aligns with
the outrigger pad. Adjust the pad to align with the rod
end as required.
13. Install the U-shaped locking pins.
14. Repeat step 1
through step 13 for each rotating bed
jacking assembly.
NOTE: Keep the crane level while deploying the rotating
bed jacking cylinders.
15. Place unused pins into the stored position for later use.
WARNING
Moving Part Hazard!
Avoid serious crushing injury. Warn all personnel to stand
clear of jacking cylinders.

Manitowoc MLC650 Specifications

General

Brand	Manitowoc
Model	MLC650
Category	Construction Equipment
Language	English