Manitowoc MLC650 - Install Position Light and Wind Speed Indicator

Manitowoc Published 08-12-19, Control # 224-13_v2 4-109
MLC650 OPERATOR MANUAL SET-UP AND INSTALLATION
4
Install Position Light and Wind Speed
Indicator
See Figure 4-83 for the following procedure:
1. Remove the camera (3) from storage in the parts box.
2. Install boom top camera (3, optional), fasten with a hair-
pin cotter (4), and connect the electric cable.
3. Remove the pins (1) from the position light and wind
speed indicator assembly (2a) from the storage lugs in
the boom top.
4. Insert the position light and wind speed indicator bracket
(2b) into the tube on the right side of the boom top and
install a safety pin (8).
5. Install the other safety pin in the top hole of the bracket.
6. Connect the electric cable (9) from the boom top to the
electric cable from the position light.
7. Connect the electric cable (10) from the boom top to the
electric cable from the wind speed indicator.