Manitowoc Published 08-12-19, Control # 224-13_v2 4-177
MLC650 OPERATOR MANUAL SET-UP AND INSTALLATION
Storing Self-Erect Cylinder
See Figure 4-136 for the following procedure:
1. Lower the rotating bed jacking cylinders (1) completely.
2. Slightly extend the self-erect cylinder (2).
3. Position the live mast (3) at approximately 85° angle (4)
so the self-erect cylinder rests on the wear pad.
4. Retract the self-erect cylinder until the pin (5) fully
engages the retention bracket (6).
To Next Page
Loading...
