Manitowoc MLC650 User Manual

Manitowoc Published 08-12-19, Control # 224-13_v2 4-183
MLC650 OPERATOR MANUAL SET-UP AND INSTALLATION
4
Disconnecting Live Mast Hydraulics and
Electrical Connectors
See Figure 4-140 for the following procedure:
1. Disconnect the drum 4 pawl hydraulic connectors (1).
2. Disconnect the drum 4 hydraulic hoses (2b) from the
working position and place the drum 4 hydraulic hoses
(2a) in the stored position.
3. Disconnect the drum 4 electrical connector (3) and store
the cable.
4. Disconnect the live mast hydraulic hoses (4b) from the
working position and place the live mast hydraulic hoses
(4a) in the stored position.
5. Disconnect the live mast electrical connector (5).
6. Disconnect the live mast grounding wire (6) from the
rotating bed.
Removing Live Mast
NOTE: The procedure shown is the same for both sides.
See Figure 4-141
for the following steps.
1. Disconnect hydraulic hoses and electrical cables and
store them.
See "Disconnecting Live Mast Hydraulics and Electrical
Connectors" on page 4-183.
2. Remove locking pin (1) and pin (2) from the stored
position and install the pin in hole (3) shipping position.
Install locking pin in the bracket hole (4) to secure.
3. Remove locking pin (5) and pin (6) from shim (7). Lower
the shim and install the locking pin.
NOTE: The shim needs to be as tight as possible to reduce
shifting during transportation.
4. Store the live mast straps as shown in View D,
page 4-42.
Item Description
1 Locking Pin
2Pin
3Hole
4 Bracket Hole
5 Locking Pin
6Pin
7Shim
FIGURE 4-141

Manitowoc MLC650 Specifications

General

Brand	Manitowoc
Model	MLC650
Category	Construction Equipment
Language	English