Manitowoc MLC650 User Manual

Manitowoc Published 08-12-19, Control # 224-13_v2 4-19
MLC650 OPERATOR MANUAL SET-UP AND INSTALLATION
4
Deploy Operator Cab Platform
NOTE: Identification labels are provided on the handrails
and platforms for ease of installation.
See Figure 4-17
for the following procedure:
1. Remove the safety pins (1) from the platform bracket.
Lower the platform into the setup position and insert
safety pins.
2. Remove the lanyard pins (3), install the handrail (2), and
install the lanyard pins.
3. Remove the quick release pins (5), rotate the cab
handrail (4), and install the quick release pins.
Start Engine
NOTE: It is normal for the system fault alert and operating
limit alert to come on when the engine is started.
The system fault alert should go off as engine oil pressure
and hydraulic oil temperature rise to normal. If alert does not
go off soon after start-up, determine fault, stop engine, and
correct cause of fault (see Main Display Operation).
Reference the Start Up Procedure found in Section 3 of this
manual.
1. Perform the pre-start checks given on page 4-17
.
2. Remove the remote control from the storage
compartment on the left side of the operator cab (see
Figure 4-12 on page 4-12
).
3. Activate the remote control. See "Activating the Remote
Control" on page 4-13.
4. Start the crane engine with the start switch on the
remote control. "Starting Engine with Remote Control"
on page 4-13
NOTE: You will not be able to increase the engine speed
until the hydraulic oil temperature is warmed to at
least 17°C (63°F).
The hydraulic temperature fault will
remain on until the hydraulic oil
temperature is 17°C (63°F). There will
be no throttle response until this
fault is cleared.

Manitowoc MLC650 Specifications

General

Brand	Manitowoc
Model	MLC650
Category	Construction Equipment
Language	English