Manitowoc MLC650 User Manual

Manitowoc Published 08-12-19, Control # 224-13_v2 4-173
MLC650 OPERATOR MANUAL SET-UP AND INSTALLATION
4
Disconnecting Carbody from Rotating Bed
See Figure 4-133 for the following procedure:
NOTE: With no blocking under the outrigger pads and with
the carbody attached to the rotating bed, the
rotating bed jacking cylinders (4) can lift the
carbody to clear a maximum trailer height (5) of
1168 mm (46 in).
1. Center the transport trailer to the carbody.
2. Using the remote control, extend the rotating bed jacking
cylinders as required to provide enough clearance
between the carbody bottom and the trailer.
3. Back the trailer under the carbody, being careful not to
hit the rotating bed jacking cylinders.
4. Lower the crane onto the trailer until the trailer deck just
starts to lower.
5. Remove the pins and collars (2b) from the front and rear
pins (1b and 3b). Place the collars with pins in the stored
position.
6. Using the remote control, retract the front and rear pins
from the working position (1b and 3b).
CAUTION
Equipment Damage!
Use extreme care when backing the trailer into position:
• Do not hit the jacking cylinders with the trailer.
• Do not hit the carbody.
Provide a signal person to give instructions to the truck
driver.
CAUTION
Overweight Hazard!
Do not lower the entire weight of the crane onto the trailer.
Weight may exceed trailer capacity.

Manitowoc MLC650 Specifications

General

Brand	Manitowoc
Model	MLC650
Category	Construction Equipment
Language	English