SET-UP AND INSTALLATION MLC650 OPERATOR MANUAL
4-34
Published 08-12-19, Control # 224-13_v2
Activate Auxiliary Hydraulic System
Before using the hand-held pin puller the auxiliary hydraulic
system must be activated. This function increases the
accessory system pressure so the hand-held pin puller can
be connected and used.
See Figure 4-27
for the following procedure:
1. Start from the first menu screen and use either the jog
dial on the right console, or the scroll keys on the display
to select the auxiliary hydraulics icon.
2. From the auxiliary hydraulics screen, scroll to the ON/
OFF (“I” or “O”) in the selection box.
3. Touch the OK button on the jog dial or display to select
the highlighted mode.
The screen changes to reflect the new mode.
FIGURE 4-27
AUXILIARY HYDRAULICS NOT ACTIVATED
AUXILIARY HYDRAULICS ACTIVATED
FIRST MENU SCREEN
To Next Page
Loading...
Need help?
General
