Manitowoc Published 08-12-19, Control # 224-13_v2 4-31
MLC650 OPERATOR MANUAL SET-UP AND INSTALLATION
Install Platforms, Ladders and Handrails
NOTE: Identification labels are provided on platforms and
handrails for ease of installation.
The rear platforms, ladders, and handrails on the
left and right side of the rotating bed (shown in
Figure 4-25
) are the same and are installed in the
same manner.
See Figure 4-25
for the following procedure:
1. Remove the two pins and quick release pins (3) from the
platform mounting brackets.
2. Using an assist crane or a forklift, raise the platform (1)
into position, align with the mounting holes in the rotating
bed brackets (2), and secure with pins and quick release
pins(3).
Platform and ladder combined weight is approximately
60 kg (133 lb).
3. Raise ladder (4) from the shipping position and attach to
the upper platform using pins (5) supplied with the upper
platform.
4. Install handrails (6) into handrail brackets and secure
with lanyard pins.
The rear handrail weighs approximately 6 kg (15 lb) and the
side handrail weighs approximately 15 kg (35 lb).
To Next Page
Loading...
Need help?
General
