2 For your own safety
safety rules and regulations that apply to the system. Random movements of the machine
or other malfunctions may be caused by deactivating, bypassing or failing to activate the
safety devices.
2.10 Protection against contact with hot parts
Risk of burns due to hot surfaces.
The servo drive and, in particular, the (external or internal) braking resistor may become
hot during operation. Always wait a sufficient amount of time prior to touching these
parts.
Always use suitable personal protective equipment to avoid severe burns.
2.11 Protection during the handling and
installation of the devices
Risk of injury caused by crushing, shearing, cutting or impacts
Improper handling and installation of certain parts will cause injuries.
Always follow the safety instructions stated hereinbelow.
l When installing the servo drive, ensure that it can be installed, operated and
removed without any danger.
l Appropriate installation clearances must also be defined.
l Comply with the intended use of the servo drive.
l When transporting the servo drive, pay particular attention to the edges and corners
of housings and other components. Use suitable personal protective equipment.
l If you install the components of the system on a wall or on the floor, dust may be
created by drilling. Use suitable personal protective equipment.
l Use only suitable installation and transport equipment.
l Prevent trapping and crushing by suitable protective measures.
l Use only suitable tools. If specified, use special tools.
l Use lifting equipment and tools in a proper manner.
l Do not step under suspended loads.
l Liquid spills on the floor must be removed immediately.
Product manual BL 4000-C Page 23 of 298
To Next Page
Loading...
Need help?
General
