14 Maintenance, cleaning, repair and disposal
14 Maintenance, cleaning, repair and
disposal
The following requirements must be fulfilled for the maintenance, cleaning, repair and
disposal of the servo drive:
Maintenance
The BL4100-C servo drive is maintenance-free.
Cleaning
Damage to the servo drive due to improper cleaning
To remove surface soiling, e.g. residues of adhesive labels, the servo drive can be
cleaned carefully on the outside with suitable tools.
It must be absolutely ensured that liquids of any kind cannot penetrate the servo drive.
Seals may be destroyed which, in turn, would to lead to short circuits.
Use the servo drive in a clean environment. Soiling due to dust, oil, oil vapour, grease,
fibres or similar inside the device will compromise the insulation with regard to the high-
voltage part. Stop using the device immediately if this is the case.
Repair
Opening the device is not permissible and will render the warranty null and void. Only the
manufacturer is authorised to perform repairs. Please contact your sales partner.
Disposal, removal, decommissioning, replacement
Dangerous electrical voltage!
Following the instructions stated hereinbelow to ensure the safe decommissioning of the
servo drive.
l Switch the power supply completely off.
l Disconnect the mains power connectors.
l Lock the system so that it cannot be reactivated.
l Check whether the device is really voltage-free (measure the voltage at the mains
power connectors and between the ZK+ and ZK- connectors at X9).
l Wait 10 minutes. Do not attempt to remove the device before this waiting period
has elapsed.
l Contact a sales partner in terms of a return or replacement of the device.
Product manual BL 4000-C Page 259 of 298
To Next Page
Loading...
Need help?
General
