Metronix smartServo BL 4104-C - Method 34: Homing to the Current Position; Parameterisation of the Homing Method

6 Applications
6.1.9 Method 34: homing to the current position
In the case of method 34, the home position refers to the current position, i.e. the current
position of the drive is set to zero.
6.1.10 Parameterisation of the homing method
Parameters/Positioning/Homing position
The homing run can be parameterised in the Homing position menu.
This is where you can select your homing method. See also section 6.1 Homing process
on page 73.
Figure 40: "Homing position" window - "Mode" tab
Product manual BL 4000-C Page 79 of 298