3 Calibration
31
In the calibration based on input of numerical value, do not use a weight. Instead, manually enter the
value to be input from the measuring unit to the CSD-709 through the front panel to adjust the value
displayed on the equipment.
In these two different types of calibrations, you should use the following procedures.
In these two types of calibrations, the actual load based calibration covers [zero calibration based on
actual load] and [span calibration based on weight] and the numerical value input based calibration
covers [entry of zero point] and [entry of span]. Which method you select is determined based on
these factors: calibration conditions and whether the weight can be prepared.
Setting of decimal point
display position
Setting of weight mass
Setting of unit weight
Registration
Span calibration based on
weight
Setting of measuring
weight
Zero calibration based on
actual load
Procedures common to actual load based calibration
and numerical value input based calibration
Actual load based
calibration
Entry of span
Entry of zero point
Numerical value input
based calibration
Changing the calibration
number
To Next Page
Loading...
Need help?
General
