5 Settings Related to Detection
61
3. The P function mode is activated, and the display changes to a two-digit numerical value
prefixed with [PF-].
4. Using and , change the numerical value to and press .
The number showing the currently set detecting section appears.
Number Detecting section
0 Entire section
1 Specified section
2 Time-specified section
3 Automatic start time-specified section
0
For setting procedures with and , see Section 1.6, "Basic key operation".
5. Press to set the value specifying the detecting section.
Whenever is pressed, the number showing the detecting section is cyclically changed
from 0 to 3, in ascending order.
6. Press .
7. Press twice to return to Measurement mode.
▼ Setting the detecting time [PF-40]
When you have selected [2] (Time-specified section) or [3] (Automatic start time-specified section) as
the desired detecting section, you should set the detecting time to P function PF-40. Described below
are the detecting time setting procedures.
1. Press once to display .
2. Press twice to change the display to .
3. Press .
The P function mode is activated, and the display changes to a two-digit numerical value
prefixed with [PF-].
4. Using and , change the numerical value to and press .
The currently set detecting time appears in [ms].
1 000 ms
For setting procedures with and , see Section 1.6, "Basic key operation".
5. Using and , set the detecting time.
You can set any value between 0 and 10 000 ms.
6. Press .
7. Press twice to return to Measurement mode.
Default
Default
To Next Page
Loading...
