B
Status • Reports
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
261
573408-001-a
5. If the input program is pre-encrypted, and pre-encryption has been selected, then the
ECM PID is also remapped or remultiplexed to the specified output stream.
Additionally, the PIT PID is extracted and reinserted into the output stream (the
output program number in the PIT is updated).
6. If the output program is being encrypted (input program is not pre-encrypted), then
the APEX1000 will mark the component PIDs with the appropriate scrambled control
bit settings and encrypt the payload of the component PIDs. Additionally, ECM
messages such as the PRK and WKE are inserted.
7. The output PAT and PMT are updated and inserted to contain the appropriate PID
and program number references.
Output Program Status window field definitions
Item Definition
Input Interface
Specifies a GigE port (1 – 4) or Enet port (1 – 2) as the input interface.
Input UDP
Identifies the input UDP port for a service (UDP port opened to receive service).
Input Multicast
Shows the Receive Multicast IP Address.
Input Source
Shows the Source IP Address.
Output TS
This column replicates the transport stream-to-output interface selections made in the
APEX1000 Output Transport Stream Configuration window.
This is the output stream that the input program is being mapped to.
Input Service
Indicates the input service as clear or pre-encrypted. Only applicable when the program
mapping has been configured to check for pre-encryption.
Encryption
Mode
Encryption mode of the program. This is the configured encryption mode based on
either the user-configured CTE encryption mode, or the RMD information received for
Broadcast encrypted services.
• Full
• FWK
• FPK
• Unencrypted/Clear
• Clear
• Pre-Encrypted
To Next Page
Loading...
Need help?
General
