Motorola APEX1000 - Page 280

B
Status • Reports
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
262
573408-001-a
Item Definition
Program Status
Output program status fields are as follows:
• Program Undefined
• Program Mapping Defined – Inactive
• Successful – Program Remultiplexed
• Program Remultiplexing Stopped
• Waiting For Input PAT
• PAT Error – Program Number Not Found
• PAT OK – Waiting For Input PMT
• PMT Error – Output PMT Unavailable
• PMT Error – Shared PID Violation
• PMT Error – Max PIDs Exceeded
• PMT Error – PCR PID Unsupported
• PMT Error – ES PIDs Unsupported
• PMT Error – ECM PID Unsupported
• PMT Error – PMT Invalid (Parsing Error)
• Encryption Error – Waiting for RMD
• Encryption Error – Waiting for Rights Meta Data
• Encryption Error – Unable to Start Encryption
• Encryption Error – Unable to Encrypt PIDs
• Encryption Error – Unauthorized for Encryption
See below for more information on Program Mapping Status field values.
The following table provides field definitions for the Program Encryption Status section
of the window:
Item Definition
ECM ID
Displays the current Entitlement Control Message ID. This is a unique ID
used internally by the APEX for generating ECM messages.
CCI
Displays the current Copy Control Information level.
APS
Displays the current Analog Protection System level.
CIT
Displays the current Constrained Image Trigger setting.
Tier/Tier Type
Displays the tier, and the tier type.
Source ID
Displays the user configured Source ID.
Provider ID
Displays the user configured Provider ID.
Description
Displays the service information based on the Source ID and Provider ID.
This is to allow easier identification of Broadcast encrypted programs.
Encryption Status
Displays the current encryption status.
PSIP Status
Displays the
PSIP Status window.
APEX Service Error Alarms
Provides an immediate alert to a new mapping that is in error.