EasyManuals Logo

Motorola APEX1000 User Manual

Motorola APEX1000
335 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #327 background imageLoading...
Page #327 background image
B
Appendix F • RS-232 Test Console Port
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
309
573408-001-a
• Reset APEX1000 EM Username and Password — Provides the ability to reset the
current username and password to the factory default values.
• Save Changes — Preserves changes from RAM to flash. This allows the changes to
take effect on the next reboot.
• Reboot Now — Causes the APEX1000 to reboot immediately; changes in RAM not
persisted to flash are discarded.
Show Enet1 Parameters Menu (Root.1)
Provides immediate display of the APEX1000 MAC address and ENET1 parameters.
Note: The actual addresses displayed are network dependent.
Eth1 IP Parameter Display
Configuration Method: IP configuration via BOOTP
protocol
Default IP address: 168.84.247.109
Default Subnet Mask: 255.255.0.0
Default Gateway: 168.84.247.1
Enet1 IP Setup (Fixed Config) Menu (Root.2)
This menu allows you to configure ENET1 with a fixed IP address and configuration.
From this menu you can access:
• Set IP address — specifies the IP address for ENET1.
• Set Subnet Mask — specifies the subnet mask for the network to which ENET1 is
attached.
• Set Gateway IP — specifies a computer/server that will act as a gateway to other
network segments.
• Save Changes — preserves changes from RAM to flash. This allows the changes to
take effect on the next reboot.
• Reboot Now — causes the APEX1000 to reboot immediately; changes in RAM not
persisted to flash are discarded.
Enet1 IP Setup (via boot protocols) Menu (Root.3)
This menu allows you to select a boot protocol, which is used to obtain an IP address
and configuration at boot time. From this menu you can access:
• Do not use boot protocols — Causes the APEX1000 to use the fixed IP
configuration specified in the previous menu. This selection cannot be made if the
APEX1000 configuration files or application files have been purged.
• Use Bootp to obtain config — Causes the APEX1000 to send a BOOTP request at
boot. If a BOOTP reply is received, the APEX1000 will use the IP configuration
assigned by the BOOTP server.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Motorola APEX1000 and is the answer not in the manual?

Motorola APEX1000 Specifications

General IconGeneral
BrandMotorola
ModelAPEX1000
CategorySwitch
LanguageEnglish

Related product manuals