3-34
Chapter 3 SETTINGS FOR FUNCTIONS
ZW
User’s Manual
Chapter 3
Setting the Output Conditions
● When holding with a key input
Press or key on the controller to enable the trigger input or reset input.
• Trigger input is ON while key is pressed.
• Reset input is ON when key is pressed.
Note that the key input is disabled in the default setting. Set the following when using
this function.
8 Press key for two seconds to enter the RUN
mode.
Steps
Key operation Display Description
1 Press key for two seconds to enter the FUN
mode.
2 Press or keys to select either of "SYSTEM"
and press key.
3 Press or keys to select either of "KEY.IN"
and press key.
4 Enable the key input.
The current setting value is displayed on the sub-
display.
Press / keys to enter the editing mode, and the
sub-display blinks.
Select "ON" and press key.
5 Press key for two seconds to enter the RUN
mode.
Steps
Key operation Display Description
RUN
FUN
TEACH
RUN
FUN
TEACH
RUN
FUN
TEACH
ZERORST/
ESC
ZERO/
SET
ZERORST/ZERORST/
ESCESC
ZERO/ZERO/
SETSET
RUN
FUN
TEACH
RUN
FUN
TEACH
To Next Page
Loading...
Need help?
General
