5-18
Chapter 5 Ethernet/RS-232C COMMUNICATION
ZW
User’s Manual
Chapter 5
Connecting Using RS-232C Cable
■ Processing unit data setting command <DS command>
Change the setting data of the processing unit.
<Command format>
<Response format>
• Normal processing
• When a command was not successfully processed
<Parameter explanation>
For unit numbers and data numbers, refer to "Processing Item Data List" (p.7-13)
Parameter Details
Unit number Specifies the unit number (0 to 255) to be acquired.
Data number Specifies the data number (0 to 255) to be acquired.
Setting value This is the setting value of the specified data.
DS
CR
㸡
Unit number
㸡
Data number
㸡
Space
㸡
Space
㸡
Setting value (N letter)
㸡
Space
OK CR
ERCR
To Next Page
Loading...
