Chapter 7 APPENDIX
Chapter 7
Updating Firmware
7-11
ZW
User’s Manual
A message indicating the start of update appears.
If the message “the model is not the same” appears when you click the [Start upgrade] button,
it means that the model of the connected controller and the model information in the specified
file do not match. In this case, do not perform update. The controller will break down and will
not start normally thereafter.
8. Check the contents of the message
and click the [OK] button.
Update of the firmware will start.
The progress status is displayed during the processing of update. Wait until the
message box indicating that the update has finished normally appears (it takes a
few minutes to complete the update).
• An error may occur on the controller during update; however, please wait.
• If the progress bar stops while update is being performed, or update does not finish normally
even after 10 minutes, there is a possibility that update may have failed.
In this case, contact an OMRON sales representative about the firmware version before
update and the one in the write file.
9. After update completes, the message appears.
Click the [OK] button.
To Next Page
Loading...
Need help?
General
