Chapter 3 SETTINGS FOR FUNCTIONS
Chapter 3
Setting Measurement Items
3-11
ZW
User’s Manual
Operating procedure
Steps
Key operation Display Description
1 Press key for two seconds to enter the FUN
mode.
2 Press or keys to select either of "MEAS" and
press key.
3 Sets the surface peak hold for TASK1 and the surface average hold for TASK2.
Setting the Hold p.3-28
4 Press or keys to select either of "TASK3"
and press key.
5 Press or keys to select either of "ITEM" and
press key.
6 Select "Calculation" as the measurement item.
The current setting value is displayed on the sub-
display.
Press / keys to enter the editing mode, and the
sub-display blinks.
Select "CALC" and press key.
7 Select "Parameter K" for the parameter type.
Press or keys to select either of "PARAM.K"
and press key.
8 Set the parameter to "0."
The current setting value is displayed on the sub-
display.
Press key to enter the editing mode, and the
sub-display blinks.
To edit numerical values use / / / keys.
Enter "0" and press key.
9 The decimal point is displayed.
Press / key to move the decimal point.
Determine the decimal point and then press the
key.
10 Press key to return to the previous menu.
RUN
FUN
TEACH
ZERORST/ZERORST/
ESCESC
ZERO/ZERO/
SETSET
ZERO/
SET
ZERORST/
ESC
ZERO/
SET
ZERO/
SET
ZERORST/ZERORST/
ESCESC
ZERO/ZERO/
SETSET
ZERORST/ZERORST/
ESCESC
ZERO/ZERO/
SETSET
ZERORST/
ESC
ZERO/
SET
ZERORST/ZERORST/
ESCESC
ZERO/ZERO/
SETSET
ZERORST/
ESC
ZERORST/
ESC
To Next Page
Loading...
