Power Down the Server for Immediate Shutdown Using the Oracle ILOM CLI
■
“Power Down the Server Gracefully Using the Oracle ILOM Web Interface” on page 57
■
“Power On the Server” on page 222
Power Down the Server for Immediate Shutdown Using the
Oracle ILOM CLI
Caution - An immediate power-off might corrupt system data, therefore, use this procedure to
power down the server only after attempting the graceful power down procedure.
1.
Log in to the Oracle ILOM command-line interface (CLI) using an Administrator
account.
Oracle ILOM displays the default command prompt (->), indicating that you have successfully
logged in to Oracle ILOM.
2.
From the CLI prompt, type the following command:
-> stop -f /System
The server powers down immediately to Standby power mode.
3.
Disconnect the power and data cables from the server.
See “Disconnect Cables From the Server” on page 61.
Caution - When you power down the server using Oracle ILOM, the server enters Standby
power mode. Power is still directed to the service processor and power supply fans. To
completely power off the server, you must disconnect the power cords from the power supplies.
Related Information
■
“Power Down the Server for Immediate Shutdown Using the On/Standby
Button” on page 60
■
“Power Down the Server for Immediate Shutdown Using the Oracle ILOM Web
Interface” on page 60
■
“Power On the Server” on page 222
Preparing for Service 59
To Next Page
Loading...
Need help?
General
