Power Down the Server Gracefully Using the On/Standby Button
The host server performs an orderly power shutdown to Standby power mode, and the
System OK LED on the front panel begins blinking. See “Server System-Level Status
Indicators” on page 31.
7.
Disconnect the power cords and data cables from the server.
See “Disconnect Cables From the Server” on page 61.
Caution - When you power down the server using Oracle ILOM, the server enters Standby
power mode. Power is still directed to the service processor and power supply fans. To
completely power off the server, you must disconnect the power cords from the power supplies.
Related Information
■
“Power Down the Server Gracefully Using the Oracle ILOM CLI” on page 56
■
“Power Down the Server Gracefully Using the On/Standby Button” on page 58
■
“Power Down the Server for Immediate Shutdown Using the On/Standby
Button” on page 60
■
“Power On the Server” on page 222
Power Down the Server Gracefully Using the On/Standby
Button
1.
Press and quickly release the On/Standby button on the front panel.
This action causes ACPI-enabled operating systems to perform an orderly shutdown of the
operating system. Servers not running ACPI-enabled operating systems shut down to Standby
power mode immediately.
When main power is off, the System OK LED on the front panel begins blinking, indicating that
the server is in Standby power mode. See “Server System-Level Status Indicators” on page 31.
2.
Disconnect the power cords and data cables from the server.
See “Disconnect Cables From the Server” on page 61.
Caution - When you power down the server using the On/Standby button, the server enters
Standby power mode. Power is still directed to the service processor and power supply fans. To
completely power off the server, you must disconnect the power cords from the power supplies.
Related Information
■
“Power Down the Server Gracefully Using the Oracle ILOM CLI” on page 56
58 Oracle Server X8-2L Service Manual • January 2021
To Next Page
Loading...
Need help?
General
