2. Set up parameters for the high-speed counter
.
Select the category of a channel to be set up in the "Category Selection" section and enter
values in the "Parameter Settings" section.
3. Select the "Counter I/O Mapping
" tab and set the correspondence (mapping) between the
channel and variable in the mapping setting pane.
Click the "Variable" column corresponding to the channel to be used by the program and
enter a variable name.
Clicking the mark in the "Mapping" column allows you to change the type of mapping.
5.4 Setting up Unit Control
5-14 WUME-GM1RTXOP-01
To Next Page
Loading...
