Use case
Applicable function
block
Restriction Remarks
C-point control for
connection between
CNC tables
PMC_NCDecoder
For details, refer to
"11.5.15 Interpolation Operation
Programming: Joining and
Repeating CNC Tables".
11.5.13 Interpolation Operation Programming: Settings in CNC Table for C-
point Control
The GM1 controller basically uses C-point control to perform operation and uses P-point control
only when paths are connected linearly
.
■
Operation example
[Setting example] C-point control
N000 G91
N010 G01 X20 Y10 F10//Path (1)
N020 G01 X20 Y10//Path (2)
N030 G01 X20 Y0//Path (3)
11.5 Multi-axis Operation
11-90 WUME-GM1RTXOP-01
To Next Page
Loading...
