Panasonic GM1 - Switching the Input Format of Parameter Values; Setting I;O Pin Assignment

The parameters will be written to the EEPROM of the servo amplifier.
15.7.4 Switching the Input Format of Parameter Values
Selected parameter values can be entered in binary or hexadecimal format.
1. Click the "Bin / Hex
" icon on the toolbar.
The Binary / Hexadecimal Input window will be displayed.
2. T
o enter parameter values in hexadecimal format, enter a value and then press the <Enter>
key. To enter parameter values in binary format, click the button corresponding to each bit
to switch between "0" and "1".
Note: If the entered value is outside the setting range of the parameter, the allowable range
will be displayed below the decimal display section.
3. After the above input operation is complete, click the [OK] button.
15.7.5 Setting I/O Pin Assignment
I/O pin assignment can be set.
The assignment can be set for the input and output related parameter
"Class 4 (I/F, monitor)".
15.7 Parameter Window
15-28 WUME-GM1RTXOP-01