Example: Multiplying the value of "x3" by 5 and outputting the value to the log
4. Click the [OK] button.
The execution point will be set. When the execution point is enabled, appears at the
execution point.
● To output a message to the log when an execution point is reached, from the menu bar, select
Project>Project Settings. In the "Project Settings" dialog box, select the
"Compile options"
category. Change the setting in Setting>Enable logging in breakpoints to "Enabled".
9.2.3 Call Stack View
In the Call Stack view, you can check a stop position when operation is stopped due to a
breakpoint or for some other reason. If the position is called from another block, the position of
the block can also be checked.
1. From the menu bar
, select View>Call Stack.
The Call Stack view will be displayed.
9.2 Breakpoint
9-8 WUME-GM1RTXOP-01
To Next Page
Loading...
