Panasonic GM1 - Capture Function

Counter_Configuration parameter setting example
■
ON hold time (for band comparison only)
When the band comparison function is used, ON hold time can be set as an output signal.
Differences in behavior between settings
ON hold time Timing chart for comparison match flag and external output signal
0
1 to 1,000 ms
■
Forced output function
●
If the Ch* external output 0* forced ON / OFF request bit is used, the external output 0 signal
and external output 1 signal can be turned ON or OFF through user programs.
● The forced output function can be used to check wiring and for other purposes.
12.6.9 Capture Function
■
Setup procedure
1. From "Device view" in the navigator pane, double-click "Counter_Configuration".
2. Click the "Counter parameter" tab.
3. For each counter, select "Capture function" and set up each parameter.
12.6 High-speed Counter Function
12-48 WUME-GM1RTXOP-01