Panasonic GM1 - I;O Mapping for High-Speed Counter Output

Setting item Settings Default value
External output 1 signal ON
hold delay
Setting range: 0 to 1,000 (ms) 0 ms
(Note 1)
"ON hold time" is enabled only when the band comparison function is used.
■
Capture function (Settable for each counter)
Setting item Settings Default value
Capture 0 setting
Not use capture 0 function
Capture function at rising edge of control 0 signal
Capture function at falling edge of control 0 signal
Capture function at rising edge of control 1 signal
Capture function at falling edge of control 1 signal
Control 0 signal positive logic sampling capture
function
Control 0 signal negative logic sampling capture
function
Control 1 signal positive logic sampling capture
function
Control 1 signal negative logic sampling capture
function
Output relay (Y relay) sampling capture function
Not use capture 0
function
Capture 1 setting
Not use capture 1 function
Capture function at rising edge of control 0 signal
Capture function at falling edge of control 0 signal
Capture function at rising edge of control 1 signal
Capture function at falling edge of control 1 signal
Not use capture 1
function
Capture function operation
setting
One operation / Continuous operation
Continuous
operation
Sampling time (ms) 1 to 65,535 1
(Note 1)
If any value related to the sampling capture function is selected for "Capture 0 setting", "Capture 1
setting" will be disabled.
12.6.4 I/O Mapping for High-speed Counter Output
The high-speed counter function is controlled by user programs.
■
InputArea (input area)
Channel Type Description Remarks
Ch*_StatusRegister WORD Ch* status register -
Ch*_ComparisonMat
chRegister
WORD
Ch* comparison
match flag
-
Ch*_CountValue DINT Ch* count value -
Ch*_Capture0Value DINT Ch* capture 0 value -
Ch*_Capture1Value DINT Ch* capture 1 value -
12.6 High-speed Counter Function
WUME-GM1RTXOP-01 12-25