Panasonic GM1 - Setting an Execution Point

● You can specify conditions under which operation is stopped when a breakpoint is reached.
From the menu bar
, select Debug>New Breakpoint. The "New Breakpoint" dialog box will be
displayed. Select the "Condition" tab and specify conditions under which operation is stopped
when a breakpoint is reached.
● The Breakpoint view allows the user to check a list of set breakpoints. You can check
breakpoint positions, break conditions, and the hit count was reached. Y
ou can also add,
delete, enable, and disable breakpoints.
To display the Breakpoint view, from the menu bar, select View>Breakpoint.
9.2.2 Setting an Execution Point
If an execution point is set, when the position of the execution point is reached, processing that
is specified beforehand can be executed and the execution result can be output to the log of the
GM1 controller
. The application does not stop at the position where an execution point is set.
1. Select a position where you want to set an execution point. From the menu bar, select
Debug>New Breakpoint.
The "New Breakpoint" dialog box will be displayed.
9.2 Breakpoint
9-6 WUME-GM1RTXOP-01