3. Click the [OK] button.
The "Select Device
" dialog box will be displayed.
8.4.2 Setting the LAN Port
The following table shows the default network settings.
When connecting GM Programmer and the GM1 controller via a LAN port, match the network
settings of the PC with those of the GM1 controller.
LAN port 1 LAN port 2
IP address 192.168.1.5 192.168.2.5
Subnet mask 255.255.255.0 255.255.255.0
Default gateway 192.168.1.1 0.0.0.0
Set the IP addresses of LAN port 1 and LAN port 2 so that their network (subnet) addresses are
dif
ferent.
Network settings can be changed using the [PLC parameters] tab of the "Device" object in the
navigator pane, as described below.
8.4 Communication Setting
WUME-GM1RTXOP-01 8-7
To Next Page
Loading...
