Panasonic GM1 - Setting Parameters with GM Programmer

up to 16 comparison match flags for each comparison condition match their respective target
values.
●
For each counter, up to two comparison match flags and external output signals can be
linked with each counter.
■
ON hold time setting (for band comparison function only)
● The ON state of external output signals is retained for the set time (1 to 1,000 ms).
■
Input time constant (noise filter)
● Input time constants can be set as input signals (A-phase, B-phase, and Z-phase) and
control signals for each counter.
12.6.2 Setting Parameters with GM Programmer
You can set parameters for the high-speed counter via Couter_Configuration in GM
Programmer.
1. From "Device view
" in the navigator pane, double-click "Counter_Configuration".
The "Counter_Configuration" setting window will be displayed.
12.6 High-speed Counter Function
WUME-GM1RTXOP-01 12-19