● Y
ou can start the GM1 controller by clicking
on the toolbar and also stop it by clicking .
●
You can select binary, decimal, or hexadecimal as the display format of the variable values to
be displayed. From the menu bar, select Debug>Display Mode and select a display format
from those shown.
● If you select confirmed online mode, a confirmation message will be displayed before you start
or stop the GM1 controller. For confirmed online mode, refer to "8.7.4 Confirmed online mode".
9.1.2 Single Cycle
You can execute the application in simulation mode in a single cycle to check whether a created
program is executed as intended.
1. After logging in, open the POU.
2. From the menu bar
, select Debug>Single Cycle or press <Ctrl+F5>.
9.1 Running and Stopping the GM1 Controller
WUME-GM1RTXOP-01 9-3
To Next Page
Loading...
