Panasonic GM1 - Linear Interpolation and Circular Interpolation

Function Description Remarks
Program-
based
movement
change
Change of parameter settings
such as target values
Using G-code to specify
parameters to be changed
and starting them from FB
(New FB must be created)
Only SMC_CNC_REF can be
used.
Repetitive execution of CNC
table
Executing a preset CNC table
(interpolation settings)
repeatedly
Dedicated FB is used (new FB
must be added).
Only SMC_CNC_REF can be
used.
11.5.2 Linear Interpolation and Circular Interpolation
The GM1 controller supports linear interpolation, circular interpolation, and helical interpolation
as interpolation controls.
■
Linear interpolation
Linear interpolation can be used for two axes or three axes.
■
Circular interpolation
Circular interpolation can be used for two axes and each axis moves along to the locus of a
circular arc.
For circular arcs, specify a center point or the radius of the circular arc.
■
Helical interpolation
Helical interpolation can be used for three axes. While performing circular interpolation, helical
interpolation allows each axis to move in parallel with the central axis of the circular arc so that
they can achieve helical motion.
11.5 Multi-axis Operation
11-50 WUME-GM1RTXOP-01