Panasonic GM1 - Creating a New Project

4.1 Creating a New Project
When creating a program using the GM Programmer for the first time, create a new project. For
the new project, set a device and a programming language to be used.
This section describes how to create a new project.
Given below is an example that explains the procedure to create a project for the GM1
controller (product number: AGM1CSRX16T) in Structured T
ext (ST) format.
1. Start up the GM Programmer
.
For details on how to start up, refer to "3.3.1 How to start".
When the GM Programmer is successfully started, the Start Page will be displayed.
2. Select "New Project
" under "Basic Operations".
The "New Project" dialog box will be displayed.
4.1 Creating a New Project
4-2 WUME-GM1RTXOP-01