Panasonic GM1 - Running, Stopping, and Single-Cycle Operations

9.1 Running and Stopping the GM1 Controller
This section explains how to run and stop the GM1 controller and how to run a single cycle
operation that is executed in units of a cycle.
9.1.1 Running and Stopping the GM1 Controller
1. After logging in, from the menu bar
, select Debug>Start or press the <F5> key.
The applications downloaded to the GM1 controller will start running.
2. From the menu bar
, select Debug>Stop, or press the <Shift> key + <F8> key
simultaneously.
The applications will be stopped.
During debug operation, you can check the current value of each variable in the declaration
section and implementation section.
9.1 Running and Stopping the GM1 Controller
9-2 WUME-GM1RTXOP-01